These wonderful cutting mats will not warp or crack after exposure to severe changes in temperature--can withstand the heat or the cold
These mats are tough enough to cut on, yet soft enough to tack into.
These mats can be rolled up for easy storage and after 30 to 45 minutes of adjusting to normal room temperature, the mats can be unrolled and the "memory" will allow the mat to relax and return to its original flat state.
These mats won't dull rotary cutter blades as fast.
You can even use the tacks/pins to attach patterns and fabrics to the mat to prevent slippage or crawling as you cut.
The red 1" grid lines extend an inch beyond the numbers for reference points when fabric is covering the center portion of the board.
You can also place these cutting mats on top of a light table for tracing or designing patterns.
Mats are 1/8" thick and translucent to allow light to pass through.

Care Instructions:

always cut with a sharp blade
use only quality rotary cutting blades - avoid using art knives or Exacto type blades on this mat.
be sure to hold your rotary cutter perfectly vertical to the mat--do not cut with the rotary cutter blade angled.
be sure to allow the mat to adjust to normal temperature after it has been in the heat or cold before unrolling.

NG-072....12" x 18" ...........$23.98

I do not stock these mats but special order the mats.
Please contact me to determine availability.

Salem Folding Square Ruler
Salem Folding Square Ruler This great product allows you to cut any size square up to 16" in length. This hinged Plexiglas ruler opens out to make a perfect 90 degree angle. Designed to take away the hassles of finding the right size square for any project that you might have, you can cut the square at any angle on your fabric. How to Use: Simply lay the ruler on your fabric. Place a pin into the Salem cutting mat at the desired size of your square in each direction as well as the corner. Flip the ruler over and mark the other corner. Cut the square. Easy! It can be used to cut bias strips. Using the mitered end, simply line it up with the outside of your mat and move it down the edge of the mat cutting the desired width of your strip as you go. It can also be used to square up your quilt or quilt pieces. NG-078......16"........$32.98 To Secure Order Page
Turntables
Large Rotating System 18x24" A 3/8" thick cast acrylic base is bolted to a heavy duty metal turntable with ball bearing construction which rotates 360 degrees for easy cutting eliminating the need to reposition the fabric. Corner edges are attached to keep the mat in place. The mat can be replaced if it becomes worn out without replacing the entire system as it is not attached to the unit. The large 18" x 24" size will handle many of your cutting needs. NG-080.....$124.98 In Stock To Secure Order Page
Back to Home Page Back to Notions Index

Salem Translucent Cutting Mats